Please follow the next steps

  1. 32P

    Prepare the root canal and trial-fit the post

  2. 33P

    Adjust the post length using a diamond disc.

  3. 34P

    Apply phosphoric acid (e.g. K-ETCHANT GEL) to the adherent surface. Leave it in place for 5 seconds before washing and drying.

  4. 35P
    Apply CLEARFIL™ CERAMIC PRIMER PLUS to the restoration surface using an application brush. There is no need to wait for the product to act. Dry the entire surface using a mild oil-free air flow.
  5. 2P

    Mix one drop each of ED PRIMER II liquid A&B.

  6. 27P

    Apply the mixture of the primers to the adherent surface and leave it for 30 seconds.

  7. 28P

    Use a cotton pellet to wipe away excess primer

  8. 29P

    Dry sufficiently by blowing mild, oil-free air.

  9. 5P

    Dispense equal amounts of PANAVIA™ F2.0 paste A and B and mix them for 20 seconds

  10. 30P

    Apply the mixture of the pastes to the post. NOTE: Don't apply paste into the root canal.

  11. 31P

    Seat the post into the root canal and spread excess paste to coronal base and light cure according to the curing timetable.

  12. 10P

    Table curing time PANAVIA™ F2.0

  13. 51P

    Place core build-up composite resin directly on PANAVIA™ F2.0 according to the manufacturer's instructions.

These procedures have been put together with the greatest care. The "standard procedure" shown above is only intended as a brief indication of the actual procedure to follow. This procedure is for general information purposes only and no rights may be derived from it. To find the detailed instructions for the correct use of the product, Kuraray Dental Benelux refers you to Kuraray Co. Ltd's instructions for use.